Zetec Jet block swapsie
Turbo Mini Forums

Hi all, wasnt sure where to put this, so i put it here!

i have a STD bore 1275 turbo block with Zetec jets fitted, and am looking to swap if with someone for one without the jets fitted. i have pics of block if anyone is interested. its been fully cleaned out too, new core plugs and gallery plugs in it too.

the reason for this, is as ive sold all my trubo stuff, im going down the 1400 route. now the jets are, i feel going to be a bit close to the bore edge for a capacity this large. the block should be ideal for +020 and +040, probably even +060, but no way +130!!

Just bare block swap. (i have the pistons / rods that came out of it too, but would need some rods in return)

if anyone is interested, let me know what you want to swap.

im in coventry by the way

Ta.

Ross

Sooperdooperturbocooperexpertengineering!

hi mate, not looking to swap, but i have some a+ and pre a+ rods going cheap if you need them. i run 1380 too

I seriously doubt it!

mate i have a good 1380 block

Paul:-
Dont need rods, only if someone take pistons too! Cheers tho.

Wolfie:-
to swap yeah? is the 1380 bores offset? (ie each pair of bores offset +010 from centre?) if so, im interested. Let me know. Ta.

Edited by mini-marauder on 26th Nov, 2005.

Sooperdooperturbocooperexpertengineering!

a far as i know there offset

it also has a steel certre main strap

as long as they are offset then yeah fine (its got to be able to take a 1399 bore) as i have the pistons already.

mail me at mr_bridger AT talktalk DOT net and well sort summat out.

anyone know how to verify an offset bore??

Sooperdooperturbocooperexpertengineering!

Still inerested??

anyone else?

Sooperdooperturbocooperexpertengineering!