1" Grommets for the floorpan / boot floor.
Turbo Mini Forums

I purchased a set from this fella - http://search.ebay.com/_W0QQfgtpZ1QQfrppZ25QQsassZwotch982
... and I kid you not, FIVE full days after paying, they were in my mailbox 2600 miles away.

They are a good quality aswell. Admittedly, whilst not as thick as the REALLY thick rubber ones used up to the mid 70's, they're thicker than most grommets I've come across in the past (the 1" ones I've got are more substantial then the ones in the picture below) - and there's more than enough in the pack for any mini - with plenty to spare!

So - if you have holes in your floor - or have those nasty steel plugs that were fitted from the mid 70's on, then these should be on the top of your shopping list!

They look good Dave, something I have done in the past with the floor grommets is to use a dab of silicone on them to seal them to the floor, stops any moisture ingress into the car from underneath, but still not too hard to get them out if required to drain the floorpans (we have all done it!)

Cool they look like the ones i bought from a minishow too. found uses for them all over my car in no time at all

Previous Engine: 1040cc Morespeed engine, 1275 turbo head T2 Turbo Mirage Manifolds Megajolt
Previous engine: STD metro turbo, megajolt
Drives: 399bananahp (flywheel) Honda Civic Vtec b18c4 T28 Turbo 1968 Mini

Megajolt maps to download: http://www.jamesfawcett.co.uk/cms/index.ph...&gid=3&Itemid=3