Page:
Home > Help Needed / General Tech Chat > removing the clutch and break master cylinder

nobbie

141 Posts
Member #: 162
Advanced Member

1st Apr, 2004 at 01:24:18am

hi ya guys i am doing my turbo conversion as we speak and it is all going good, why i have the engine out of the car i am going to be removing the front subframe to give it a lick of paint, i am not quite sure on how to remove the clutch and break cylinder, can any one give me some advice please.

wil_h

User Avatar

9258 Posts
Member #: 123
Post Whore

Betwix Harrogate and York

1st Apr, 2004 at 07:59:23am

Easy

1) Take off all the pipes from the master cylinders
2) Remove the split pins from the pedal to cylinder locating dowells (can't think of a better name for them), then remove the dowells. All this lot is found at the top of the pedals inside the car and is a git to get at.
3) Undo the nuts holding the master cylinders in place and pull them off.

Wil

Fastest 998 mini in the world? 13.05 1/4 mile 106mph



On 2nd Jan, 2013 fastcarl said:
the design shows a distinct lack of imagination,
talk about starting off with a clean sheet of paper, then not bothering to fucking draw on it,lol

On 20th Apr, 2012 Paul S said:
I'm mainly concerned about swirl in the runners caused by the tangential entry.


nobbie

141 Posts
Member #: 162
Advanced Member

1st Apr, 2004 at 09:21:52am

cheers mate

mini-marauder

User Avatar

265 Posts
Member #: 68
Senior Member

Coventry

1st Apr, 2004 at 12:24:14pm

Clevis pins *wink*

Sooperdooperturbocooperexpertengineering!

wil_h

User Avatar

9258 Posts
Member #: 123
Post Whore

Betwix Harrogate and York

1st Apr, 2004 at 12:41:34pm

Thank you

Fastest 998 mini in the world? 13.05 1/4 mile 106mph



On 2nd Jan, 2013 fastcarl said:
the design shows a distinct lack of imagination,
talk about starting off with a clean sheet of paper, then not bothering to fucking draw on it,lol

On 20th Apr, 2012 Paul S said:
I'm mainly concerned about swirl in the runners caused by the tangential entry.


turbodave16v
Forum Mod

10980 Posts
Member #: 17
***16***

SouthPark, Colorado

1st Apr, 2004 at 05:39:11pm

If you are struggling - take out the drivers seat and maybe the column. If you've never done it before (and aren't a contortionist), it can be tricky to figure out how you do it....

On 17th Nov, 2014 Tom Fenton said:
Sorry to say My Herpes are no better


Ready to feel Ancient ??? This is 26 years old as of 2022 https://youtu.be/YQQokcoOzeY



nobbie

141 Posts
Member #: 162
Advanced Member

1st Apr, 2004 at 06:38:30pm

yea i got them both off today thanks guys - no probs
Home > Help Needed / General Tech Chat > removing the clutch and break master cylinder
Users viewing this thread: none. (+ 1 Guests)  
To post messages you must be logged in!
Username: Password:
Page: