Wheel Bearing Trouble!
Turbo Mini Forums

Hello!

Ive just come to the point of building my new hubs, and tonight have been trying to get the shell on wheels. 8)

Got the first hub in and put the CV joint through with the disk and flange on the other side fine.

The passengers side hub went in, but then i slid the CV joint through and it seems to wobble on the bearing.

So I put the disk on and tightened it up thinking it might pull something tighter but no luck. So if I was to put the wheel on now, it would wobble.

Ive looked at the bearing and its both of the inner bearing races wobbling.

Im not sure if its because I havnt pressed the bearings in far enough?

Gonna have another look tomrrow night, but just wondered if anyone has had the same problem and solved it?

Thanks,

Ben.

Edited by Ben. on 19th Aug, 2007.

Build Thread Click Here

so the bearings are ne?

its it jam packed with grease?

if theyre the tapered ones, the inner races will wobble a bit as theyre just sat there, only the seals stopping themfrom falling out.

"Turbo's make torque, and torque makes fun"

"did you know you can toast potato waffles?"

just thought, have you put them in the right way?

"Turbo's make torque, and torque makes fun"

"did you know you can toast potato waffles?"