megajolt and tacho
Turbo Mini Forums

Hi,

i'm installing megajolt to my car and i got it running on the edis limp mode:)

But now i noticed mine tacho is not working. what must happen to get it working again. I see megajolt has a rpm output but were do i connect that? Which wire goes where?

Searched but could not fing the answer or will this also work for the jolt?

http://www.turbominis.co.uk/forums/index.php?p=vt&tid=388882

Edited by paneermeel on 18th Oct, 2010.

there is nothing wrong with a A-series that a turbo can't fix.

www.turbomini.nl

I ran the mjlj tacho out wire straight onto the back of my standard 3 clock rev counter, and it works perfectly straight off.

I connected it to the pin that previously had the black and white wire running to it (from the coil)

On EDIS only the tacho won't work though, as it's driven by the megajolt

Mr. Prawn, the friendly Crustacean- slowly making steps towards forced induction.

On edis only no tacho, i understand that.

But tomorrow i hope to get the Megajolt connected and then fingers crossed i hope it still runs and i have a revcounter

there is nothing wrong with a A-series that a turbo can't fix.

www.turbomini.nl