Page:
Home > Help Needed / General Tech Chat > MPI Throttle body dimensions

Graham T

User Avatar

608 Posts
Member #: 1106
Post Whore

Hungerford, Berks

5th Jun, 2017 at 03:13:57pm



I'm Not sure if one of you good people can help, but as per the title, I’m looking for some basic dimensions on the MPI throttle body:

Total height (Mating face with Plenum to “inlet mouth”)
Width of the land that I guess the air cleaner would attach to (the part with the o’ring seal)
Diameter of previous.

I’m looking to replace my AT Power throttle body if I can, perhaps with one of the Burlen 52mm Twin point Throttle body’s, but clearance to the bonnet is going to be a bit tight I think, hence requiring Dim’s.


Much appreciated

Graham

’77 Clubman build thread
http://www.turbominis.co.uk/forums/index.php?p=vt&tid=618189

Siamese 5 port EFI testing
http://www.turbominis.co.uk/forums/index.php?p=vt&tid=611675

Home > Help Needed / General Tech Chat > MPI Throttle body dimensions
Users viewing this thread: none. (+ 1 Guests)  
To post messages you must be logged in!
Username: Password:
Page: