Saab 2.3 Gt1752 fitting
Turbo Mini Forums

Hey I have been off and on here for a while and after
Getting my turbo up and running after 1000mile
My brand new t2 from mirage packed up
So I have got one of these gt1752 turbos
I no it fits on my mirage manifold and I no I need the
Top part of the down pipe so I can get the flange for
My exhaust but what else do I need boys Nd girls
I did search but not to much came up thx

http://www.turbominis.co.uk/forums/index.php?p=vt&tid=445578

this is a good build thread to give you some direction http://www.turbominis.co.uk/forums/index.p...id=448248&fr=50

As for the turbo inlet, I wouldn't weld anything on byt rather just use a reducing silicon elbow with a jubilee clip.

You will have to do something with the actuator bracket. I know you have the bulkhead box so the original position of the actuator will be ok, but since you will have to rotate the compressor housing the actuator bracket will be all wrong. again, I would fabricate something up that will bolt up using the screws for the compressor housing. http://www.turbominis.co.uk/forums/index.php?p=vt&tid=503051


The oil drain should be easy enough again.

Oil feed hose end may be different from the T2?..... I don't know.

This might be important too http://www.turbominis.co.uk/forums/index.php?p=vt&tid=197391

Edited by Sprocket on 14th May, 2013.