Page:
Home > Help Needed / General Tech Chat > Mpi block oil return?

Will

167 Posts
Member #: 11091
Advanced Member

18th Mar, 2015 at 07:36:44am

As the casting of the block doesnt have a mechanical fuel pump what do people use?
I gather tap & dying into where the camshaft sensor goes?

apbellamy

User Avatar

16540 Posts
Member #: 4241
King Gaycharger, butt plug dealer, Sheldon Cooper and a BAC but generally a niceish fella if you dont mind a northerner

Rotherham, South Yorkshire

18th Mar, 2015 at 09:15:32am

Or return it through the gearbox casing just below the engine flange.

On 11th Feb, 2015 robert said:
i tried putting soap on it , and heating it to brown , then slathered my new lube on it

*hehe!*

Gomme

User Avatar

53 Posts
Member #: 10528
Advanced Member

Denmark

18th Mar, 2015 at 01:23:32pm

I put mine in the gearbox, just below the engine flange.

dan187

User Avatar

774 Posts
Member #: 6724
Post Whore

Wootton Bassett

18th Mar, 2015 at 09:28:31pm

I haven't got round to fitting the turbo on mine yet but drilled holes when building the engine so that I could copy this idea...

1275 N/A Sprite, 998 T2 Turbo Mayfair
1275 EFi Turbo

Will

167 Posts
Member #: 11091
Advanced Member

18th Mar, 2015 at 09:47:14pm

Looks good and probably the easiest to do
not sure whether to go for the snap on fittings or tap something like this into the plate on the gearbox


just abit concerned about creating another place for oil to leak from haha

Edited by Will on 18th Mar, 2015.


Will

167 Posts
Member #: 11091
Advanced Member

18th Mar, 2015 at 09:57:52pm

5/8 tail should do the job?
or 3/4?
Home > Help Needed / General Tech Chat > Mpi block oil return?
Users viewing this thread: none. (+ 1 Guests)  
To post messages you must be logged in!
Username: Password:
Page: